It used to be as long as we watched the same 2 channels, so for my example lets say 705 (Fox 5) and 899 (HBO), as long as I stayed on those same 2 channels, I could go back and forth between the 2 channels and Rewind. So if I was on 705, pressed Last on the remote to go to 899, watch 899 for 10 minutes, go back to 705, I could rewind 705, and vice versa if I went back to 899 from 705.
If I went to a 3rd channel, that would cancel it out and I would no longer be able to rewind on the original 1st channel.
This feature is no longer working. Tried seeing if it was a setting somewhere but did not find anything. I feel like it has been happening for at least a month and I am finally at the point I am seeing if there is a fix for it.
I have just powered down all of the STB's. It is a Multi Room DVR setup so did them all. I have not powered down the router as well and that is primarily because about 2 days ago we lost power completely, so it has been reset already since this has been happening. I am willing to try it again (the router), that is just a bit of a process as I also have an Orbi setup in AP mode with additional switches connected to it as well, so when I restart my router I have to power down about 3 other things as well, so try to avoid it when I can especially since my internal network itself is configured pretty rock solid.
Any help or advice is appreciated. We did not use it a whole lot, but when we did it was usually because two shows were on at the same time we wanted to watch so it was very helpful.
A few things I can add. Rewinding "Live TV" still does work. So if we are just watching Channel 705, I can rewind it.